We're here to help

    Installing a serial module

    Follow

    Thermal Printer Module Upgrade

    1. You will need a small Phillips screwdriver.
      1. The module is located at the BACK of the printer and is held in by 2 screws. Remove all cables and remove the old module – put in your new module.
      2. This is a module: 
      3. Once the module is in place, turn printer upside down, remove the silver panel that is held in by one screw – inside the printer are the dip switches.

     

    Note: If the dipswitches are improperly set the printer will not work.

    DSW1                    7 on  (if you had parallel they are already off, if you had serial then 7 is on)

    DSW2                    4 on 

     

    If this is not an existing printer, you will need to call CDP to download the logo into the printer

     

     

     

    Was this article helpful?
    0 out of 0 found this helpful

    Comments